Some of my Favourite youtuber

troye
jack and finn harris - jacks gap
zoellea
macbarbie07
sam pepper
casper lee
thatcher joe
pointless blog


comment your favourite's below

How to do A waterfall braid

Prepare hair for braiding. Hair braids best when it is damp, clean and fully brushed before braiding.

• Wash and condition your hair. Remove excess water using a clean towel. The braiding will be most successful if you don’t fully dry your hair.

Brush out any knots with a wide tooth comb. Brush underneath the nape of the neck to ensure no knots remain.

Part your hair in the middle.

spaceplay / pause

escstop

ffullscreen

shift + ←→slower / faster (latest Chrome and Safari)

↑↓volume

mmute

←→seek

 . seek to previous

12…6 seek to 10%, 20%, …60%

Section off the top third of your hair. Begin sectioning from your forehead and part. Use the wide tooth comb to section off your hair and hold the section in one hand.

• Divide the section into three parts                                                                                 Braid the hair toward the back of your head in a French braid style. After the first pass, begin working outside pieces of hair into your braid so that you're essentially French braiding your hair.                                                                                    Create that “waterfall” look. When you’ve reached the last part of the first braid section, drop the last strand of hair. This will make it look like the hair is cascading from the braid.                                                                                                                         Pick up a new strand of hair located next to the strand you’ve dropped to replace that strand. Continue the waterfall look by picking the next section of hair located beside the hair section you dropped and continue braiding.
• Continue braiding by cascading the braid toward the middle of the head. Repeat the initial step by continuing the braid and then dropping the last section of hair, but then picking up a section next to the dropped hair section.                                                                                                                  Secure the braid with bobby pins if needed. Keep bobby pins on hand to provide additional support or to keep errant hair in place.                               Braid the remaining “tail” until you run out of hair                                      Decorate. Finish with a small hair tie or clip that matches your outfit. Do not use an office rubber band as it will get stuck in your hair and damage it, but orthodontic rubber bands work well. Depending on the event, you could either integrate a matching clip or hide the hair tie into your tail by choosing a tie in the same color as your hair.

from wiki how